Displaying Port Monitor Status And Policies - Cisco MDS 9000 Series Configuration Manual

Configuring Interfaces
switch# show interface fc8/3
fc8/3 is down (Error disabled - port down due to trustsec violation) Hardware is Fibre
Channel, SFP is short wave laser w/o OFC (SN) Port WWN is 21:c3:00:0d:ec:10:57:80
Admin port mode is E, trunk mode is on snmp link state traps are enabled
Port vsan is 1
Receive data field Size is 2112 Beacon is turned off
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
11274 frames input, 1050732 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
11242 frames output, 971900 bytes
0 discards, 0 errors
11 input OLS, 34 LRR, 10 NOS, 0 loop inits
72 output OLS, 37 LRR, 2 NOS, 0 loop inits
Interface last changed at Sun Nov 27 07:34:05 1988
An interface may be error disabled for several reasons. To recover an error-disabled interface, use the shutdown
and no shutdown commands in interface configuration mode to re-enable the link.

Displaying Port Monitor Status and Policies

The following commands display information about the Port Monitor feature:
Note The port Logical type is displayed as the Port type.
switch# show port-monitor
-------------------------------------------------------------------------------------------
Port Monitor : enabled
-------------------------------------------------------------------------------------------
Congestion-Isolation : enabled
-------------------------------------------------------------------------------------------
Policy Name
Admin status : Not Active
Oper status
Port type
--------------------------------------------------------
----------------------------------------------------------------------
Counter
Warning Threshold
-------
--------------------- --------------
Link Loss
Not enabled
Sync Loss
Not enabled
Signal Loss
Not enabled
Invalid Words
Not enabled
Invalid CRC's
Not enabled
State Change
Not enabled
TX Discards
: default
: Not Active
: All Ports
Threshold Interval Rising Threshold event Falling Threshold
PMON Portguard
--------- -------- ---------------- ----- ------------------ -----
Delta 60
Not enabled
Delta 60
Not enabled
Delta 60
Not enabled
Delta 60
Not enabled
Delta 60
Not enabled
Delta 60
Not enabled
Delta 60
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
Displaying Port Monitor Status and Policies
5 4 1
5 4 1
5 4 1
1 4 0
5 4 1
5 4 0
200 4 10
event
4
4
4
4
4
4
4
71