Show Lldp - Dell PowerConnect J-EX4200-24T Software Manual

show lldp

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Table 311: show lldp Output Fields
Field Name Field Description
LLDP operating state. The state can be
LLDP
NOTE: If a VLAN that has been configured for untagged packets on an interface
also has Layer 2 protocol tunneling (L2PT) enabled for LLDP, the LLDP operating
state for that interface is displayed as
Advertisement interval Frequency, in seconds, at which LLDP advertisements are sent.
This value is set by the
Delay between two successive LLDP advertisements. The delay is set to 2
Transmit delay
seconds.
Multiplier used in combination with the
Hold timer
the length of time LLDP information is held before it is discarded.
This value is set by the
show lldp
<detail>
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Display information about Link Layer Discovery Protocol (LLDP) and Link Level Discovery
Protocol–Media Endpoint Discovery (LLDP-MED) configuration and capabilities on the
switch. LLDP and LLDP-MED are used to learn about and to distribute device information
on network links.
none —Display LLDP information for all interfaces.
—(Optional) Display detailed LLDP information for all interfaces.
detail
view
Configuring LLDP (CLI Procedure) on page 2344
Configuring LLDP-MED (CLI Procedure) on page 2346
Understanding 802.1X and LLDP and LLDP-MED on J-EX Series Switches on page 2261
show lldp on page 2492
show lldp (detail) on page 2492
Table 311 on page 2489 lists the output fields for the
listed in the approximate order in which they appear.
advertisement-interval
hold-multiplier
Chapter 86: Operational Commands for 802.1X
show lldp
or .
enabled disabled
disabled .
configuration statement.
value to determine
advertisement-interval
configuration statement.
command. Output fields are
Level of Output
All levels
All levels
All levels
All levels
2489