Port-Error-Disable - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS

port-error-disable

Syntax
Hierarchy Level
Release Information
Description
Default
Required Privilege
Level
Related
Documentation
2688
port-error-disable {
disable-timeout timeout ;
}
[edit ethernet-switching-options]
Statement introduced before Junos OS Release 10.2 for J-EX Series switches.
Disable rather than block an interface when enforcing MAC limiting, MAC move limiting,
and rate-limiting configuration options for shutting down the interface; and allow the
interface to recovery automatically from the error condition after a specified period of
time:
NOTE: The port-error-disable
error conditions. It impacts only error conditions that are detected after
port-error-disable
error condition and restore the interface to service, use the clear
ethernet-switching port-error command.
If you have enabled mac-limit with the
the switch disables (rather than shuts down) the interface when the MAC address limit
is reached.
If you have enabled mac-move-limit with the
, the switch disables (rather than shuts down) the interface when
port-error-disable
the maximum number of moves to a new interface is reached.
If you have enabled storm-control with the
, the switch disables (rather than shuts down) the interface when
port-error-disable
broadcast traffic and unknown unicast traffic exceeds the specified levels.
Not enabled.
routing—To view this statement in the configuration.
routing–control—To add this statement to the configuration.
Configuring Autorecovery From the Disabled State on Secure or Storm Control Interfaces
(CLI Procedure) on page 2516
Configuring Port Security (CLI Procedure) on page 2626
Example: Configuring Storm Control to Prevent Network Outages on J-EX Series
Switches on page 2513
configuration does not apply to pre-existing
has been enabled and committed. To clear a pre-existing
option and enable
shutdown
shutdown
action-shutdown
port-error-disable
option and you enable
option and you enable
,