Dell PowerConnect J-EX4200-24T Software Manual page 2817

Table 338: Action Modifiers for Firewall Filters (continued)
Action Modifier
count counter-name
forwarding-class class
interface interface-name
log
loss-priority (high | low)
policer policer-name
syslog
Related
Documentation
Description
Count the number of packets that pass this filter, term,
or policer.
Classify the packet in one of the following forwarding
classes:
assured-forwarding
best-effort
expedited-forwarding
network-control
Forward the traffic to the specified interface bypassing
the switching lookup.
NOTE: interface is not a supported action modifier for
IPv6 traffic.
Log the packet's header information in the Routing
Engine. To view this information, issue the
log command in the CLI.
NOTE: log is not a supported action modifier for IPv6
traffic.
Set the packet loss priority (PLP).
Apply rate limits to the traffic.
You can specify a policer for ingress port, VLAN, and
router firewall filters only.
Log an alert for this packet. You can specify that the
log be sent to a server for storage and analysis.
NOTE: is not a supported action modifier for
syslog
IPv6 traffic.
NOTE: On J-EX Series switches,
supported for firewall filters applied on loopback interfaces.
Firewall Filter Configuration Statements Supported by Junos OS for J-EX Series Switches
on page 2806
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on J-EX Series
Switches on page 2755
Example: Using Filter-Based Forwarding to Route Application Traffic to a Security
Device on J-EX Series Switches on page 2773
Chapter 100: Firewall Filters—Overview
Supported Platforms and Direction
J-EX4200—ingress and egress
J-EX8200—not supported
J-EX4200—ingress and egress
J-EX8200—ingress and egress
J-EX4200—ingress only
J-EX8200—ingress only
J-EX4200—ingress only
show firewall
J-EX8200—ingress only
J-EX4200—ingress only
J-EX8200—not supported
J-EX4200—ingress only
J-EX8200—ingress only
J-EX4200—ingress only
J-EX8200—ingress only
and
accept discard
are the only actions
2745