Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Specifying Policers in a Firewall Filter Configuration
Applying a Firewall Filter That Is Configured with a Policer
Related
Documentation
2790
Discard is the only supported policer action.
To reference a policer for a single firewall, configure a filter term that includes the policer
action:
[edit firewall family ethernet-switching]
user@switch# set filter limit-hosts term term-one from source-address 192.0.2.16/28
user@switch# set filter limit-hosts term term-one then policer policer-one
A firewall filter that is configured with one or more policer actions, like any other filter,
must be applied to a port, VLAN, or Layer 3 interface. For information about applying
firewall filters, see the sections on applying firewall filters in "Configuring Firewall Filters
(CLI Procedure)" on page 2779.
NOTE: You can include policer actions on ingress firewall filters only.
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on J-EX Series
Switches on page 2755
Configuring Firewall Filters (CLI Procedure) on page 2779
Configuring Firewall Filters (J-Web Procedure) on page 2784
Verifying That Policers Are Operational on page 2800
Understanding the Use of Policers in Firewall Filters on page 2752