Configuring 802.1X Authentication (J-Web Procedure) - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Related
Documentation

Configuring 802.1X Authentication (J-Web Procedure)

2332
Configure how long, in seconds, the interface waits before retransmitting the initial
5.
EAPOL PDUs to the supplicant:
[edit protocols dot1x]
user@switch# set authenticator interface ge-0/0/5 transmit-period 60
Configure the maximum number of times an EAPOL request packet is retransmitted
6.
to the supplicant before the authentication session times out:
[edit protocols dot1x]
user@switch# set authenticator interface ge-0/0/5 maximum-requests 5
Configuring 802.1X Authentication (J-Web Procedure) on page 2332
Example: Setting Up VoIP with 802.1X and LLDP-MED on a J-EX Series Switch on
page 2302
Monitoring 802.1X Authentication on page 2355
Verifying 802.1X Authentication on page 2356
Configuring LLDP (CLI Procedure) on page 2344
Understanding Authentication onJ-EX Series Switches on page 2248
To configure 802.1X settings on a J-EX Series switch using the J-Web interface:
Select >
1. Configure Security
The 802.1X screen displays a list of interfaces, whether 802.1X security has been
enabled, and the assigned port role.
When you select an interface, the
802.1X details for that interface.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes (J-Web Procedure)"
on page 334 for details about all commit options.
Click one:
2.
RADIUS Servers—Specifies the RADIUS server to be used for authentication. Select
the check box to specify a server. Click
server settings. Enter information as specified in Table 296 on page 2333.
Exclusion List—Excludes hosts from the 802.1X authentication list by specifying the
MAC address. Click
Add
MAC addresses. Enter information as specified in Table 297 on page 2333.
Edit—Specifies 802.1X settings for the selected interface
> .
802.1X
Details of 802.1x configuration on port
Commit Options
or
Add Edit
or in the Exclusion list screen to include or modify the
Edit
section displays
> . See "Using the
Commit
to add or modify the RADIUS