Dell PowerConnect J-EX4200-24T Software Manual page 2857

Table 343: Create a New Filter
Field Function
Filter tab
Filter type Specifies the filter type: port/VLAN firewall filter or
router firewall filter.
Filter name Specifies the name for the filter.
Select terms to be part Specifies the terms to be associated with the filter. Add
of the filter new terms or edit existing terms.
Association tab
Port Associations Specifies the ports with which the filter is associated.
NOTE: For a port/VLAN filter type, only Ingress direction
is supported for port association.
VLAN Associations Specifies the VLANs with which the filter is associated.
NOTE: Because router firewall filters can be associated
with ports only, this section is not displayed for a router
firewall filter.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes (J-Web Procedure)"
on page 334 for details about all commit options.
Click one:
2.
—Select this option to create a new filter. Enter information as specified in Table
Add
343 on page 2785.
Edit —Select this option to edit an existing filter. Enter information as specified in
Table 343 on page 2785.
—Select this option to delete a filter.
Delete
Term Up —Select this option to move a term up in the filter term list.
—Select this option to move a term down in the filter term list.
Term Down
Chapter 102: Configuring Firewall Filters
Commit Options > Commit
Your Action
Select the filter type.
Enter a name.
Click Add to add new terms. Enter
information as specified in Table 344 on
page 2786 and Table 345 on page 2786.
1. Click Add .
2. Select the direction: Ingress or Egress.
3. Select the ports.
4. Click OK .
1. Click .
Add
2. Select the direction: Ingress or Egress.
3. Select the VLANs.
4. Click .
OK
. See "Using the
2785