Chapter 103 Verifying Firewall Filter Configuration - Dell PowerConnect J-EX4200-24T Software Manual

CHAPTER 103
Verifying Firewall Filter Configuration
Verifying That Firewall Filters Are Operational
Purpose
Action
Meaning
Related
Documentation
Verifying That Firewall Filters Are Operational on page 2799
Verifying That Policers Are Operational on page 2800
Monitoring Firewall Filter Traffic on page 2800
After you configure and apply firewall filters to ports, VLANs, or Layer 3 interfaces, you
can perform the following task to verify that the firewall filters configured on J-EX Series
switches are working properly.
Use the operational mode command to verify that the firewall filters on the switch are
working properly:
user@switch> show firewall
Filter: egress-vlan-watch-employee
Counters:
Name
counter-employee-web
Filter: ingress-port-voip-class-limit-tcp-icmp
Counters:
Name
icmp-counter
Policers:
Name
icmp-connection-policer
tcp-connection-policer
Filter: ingress-vlan-rogue-block
Filter: ingress-vlan-limit-guest
The show firewall command displays the names of all firewall filters, policers, and counters
that are configured on the switch. For each counter that is specified in a filter configuration,
the output field shows the byte count and packet count for the term in which the counter
is specified. For each policer that is specified in a filter configuration, the output field
shows the packet count for packets that exceed the specified rate limits.
Configuring Firewall Filters (CLI Procedure) on page 2779
Configuring Firewall Filters (J-Web Procedure) on page 2784
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 2788
Bytes Packets
0
Bytes Packets
0
Packets
0
0
0
0
2799