Dell PowerConnect J-EX4200-24T Software Manual page 2868

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 347: Terms Configuration Parameters (continued)
Field Function
Action Specifies the action to take if the conditions match.
Default Action Specifies that any action that is intrinsic to the protocol is
overridden. This action is also nonterminating, so that various
policy terms can be evaluated before the policy is terminated.
Next Specifies the default control action if a match occurs, and there
are no further terms in the current routing policy.
Priority Specifies a priority for prefixes included in an OSPF import
policy. Prefixes learned through OSPF are installed in the
routing table based on the priority assigned to the prefixes.
BGP Origin Specifies the BGP origin attribute.
AS Path Prepend Affixes an AS number at the beginning of the AS path. The AS
numbers are added after the local AS number has been added
to the path. This action adds an AS number to AS sequences
only, not to AS sets. If the existing AS path begins with a
confederation sequence or set, the affixed AS number is placed
within a confederation sequence. Otherwise, the affixed AS
number is placed with a nonconfederation sequence.
AS Path Expand Extracts the last AS number in the existing AS path and affixes
that AS number to the beginning of the AS path n times, where
n is a number from 1 through 32. The AS number is added before
the local AS number has been added to the path. This action
adds AS numbers to AS sequences only, not to AS sets. If the
existing AS path begins with a confederation sequence or set,
the affixed AS numbers are placed within a confederation
sequence. Otherwise, the affixed AS numbers are placed within
a nonconfederation sequence. This option is typically used in
non-IBGP export policies.
Load Balance Per Specifies that all next-hop addresses in the forwarding table
Packet must be installed and have the forwarding table perform
per-packet load balancing. This policy action allows you to
optimize VPLS traffic flows across multiple paths.
Tag Specifies the tag value. The tag action sets the 32-bit tag field
in OSPF external link-state advertisement (LSA) packets.
Metric Changes the metric (MED) value by the specified negative or
positive offset. This action is useful only in an external BGP
(EBGP) export policy.
Route Specifies whether the route is external.
Preference Specifies the preference value.
2796
Your Action
Select a value from the list.
Select a value from the list.
Select a value from the list.
Select a value from the list.
Select a value from the list.
Enter a value.
Select the type and type a value.
Select the check box to enable the option.
Select the action and type a value.
Select the action and type a value.
Select the External check box to enable
the option, and select the OSPF type.
Select the preference action and type a
value.