Configuring Policers To Control Traffic Rates (Cli Procedure) - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 345: Advanced Options for Terms (continued)
Table Function
Fragmentation Specifies the IP fragmentation flags.
Flags
NOTE: Fragmentation flags are supported on ingress ports, VLANs,
and router interfaces.
Dot1q tag Specifies the value for tag field in the Ethernet header. Values can be
from 1 through 4095.
NOTE: This option is not applicable for a routing filter.
Action
Counter name Specifies the count of the number of packets that pass this filter, term,
or policer.
Forwarding class Classifies the packet into one of the following forwarding classes:
assured-forwarding
best-effort
expedited-forwarding
network-control
user-defined
Loss priority Specifies the packet loss priority.
NOTE: Forwarding class and loss priority should be specified together
for the same term.
Analyzer Specifies whether to perform port-mirroring on packets. Port-mirroring
copies all packets entering one switch port to a network monitoring
connection on another switch port.
Related
Documentation

Configuring Policers to Control Traffic Rates (CLI Procedure)

2788
Configuring Firewall Filters (CLI Procedure) on page 2779
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on J-EX Series
Switches on page 2755
Verifying That Firewall Filters Are Operational on page 2799
Firewall Filters for J-EX Series Switches Overview on page 2721
Firewall Filter Match Conditions and Actions for J-EX Series Switches on page 2728
You can configure policers to rate limit traffic on J-EX Series switches. After you configure
a policer, you can include it in an ingress firewall filter configuration.
When you configure a firewall filter, you can specify a policer action for any term or terms
within the filter. All traffic that matches a term that contains a policer action goes through
Your Action
Select either the option
or enter a
is-fragment
combination of fragment action
flags.
Enter the value.
Enter a value.
Select the option from the list.
Enter the value.
Select the analyzer (port
mirroring configuration) from the
list.