Configuring Firewall Filters (J-Web Procedure) - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Related
Documentation

Configuring Firewall Filters (J-Web Procedure)

2784
user@switch# set ge-0/1/0 unit 0 family inet address 10.10.10.1/24 filter input
ingress-router-filter
To apply a firewall filter to filter packets that are exiting a Layer 3 interface:
[edit interfaces]
user@switch# set ge-0/1/0 unit 0 family inet address 10.10.10.1/24 filter output
egress-router-filter
NOTE: You can apply no more than one firewall filter per Layer 3 interface,
per direction.
Configuring Firewall Filters (J-Web Procedure) on page 2784
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on J-EX Series
Switches on page 2755
Example: Using Filter-Based Forwarding to Route Application Traffic to a Security
Device on J-EX Series Switches on page 2773
Verifying That Firewall Filters Are Operational on page 2799
Monitoring Firewall Filter Traffic on page 2800
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 2788
Assigning Multifield Classifiers in Firewall Filters to Specify Packet-Forwarding Behavior
(CLI Procedure) on page 2791
Firewall Filter Match Conditions and Actions for J-EX Series Switches on page 2728
Firewall Filters for J-EX Series Switches Overview on page 2721
You configure firewall filters on J-EX Series switches to control traffic that enters ports
on the switch or enters and exits VLANs on the network and Layer 3 (routed) interfaces.
To configure a firewall filter you must configure the filter and then apply it to a port, VLAN,
or Layer 3 interface.
To configure firewall filter settings using the J-Web interface:
Select >
1. Configure Security
The Firewall Filter Configuration page displays a list of all configured port/VLAN or
router filters and the ports or VLANs associated with a particular filter.
> .
Filters