Entering A Treatment Parameter - Fresenius Medical Care 2008T Operator's Manual

Chapter 3—Setting Treatment Parameters

Entering a Treatment Parameter

Treatment parameters can be entered quickly and easily using the 2008T Keyboard,
Touchpad, and optional Touchscreen. All editable treatment data are displayed in yellow
rectangular buttons in the treatment screens. To change a treatment parameter in any screen,
highlight the parameter to change by selecting the corresponding button on the display
screen. The selected button changes to a brighter shade of yellow when highlighted. Enter
the new value using the numbers or  /  (up or down) keys located on the Keyboard. After
entering the new value, press the CONFIRM key to save it in the 2008T hemodialysis
machine's memory. The following example illustrates this procedure.
To set a treatment parameter:
Figure 27 – Entering Treatment Parameters
62
Note: If an incorrect parameter value was entered, press the Escape
key on the Touchpad or the Esc key on the Keyboard to cancel.
You can only cancel an entry before the CONFIRM key has been
pressed. If a parameter value entry has been confirmed, follow steps
1 - 3 to re-enter the correct parameter value.
2008T Machine Operator's Manual P/N 490122 Rev N
1) Using UF Goal as an
example, a treatment
parameter can be selected
in two different ways:
 Touch the button directly
with the Touchscreen.
 Slide your finger along the
Touchpad to move the
cursor arrow until the
desired button is
highlighted. Then either
tap the Touchpad or press
the CONFIRM key.
When the button is selected,
it becomes a brighter yellow.
2) Use the number or
arrow keys on the
Keyboard to enter the
desired value.
3) After entering the
value, either tap the
Touchpad or press
CONFIRM (or Enter
on the Keyboard) to
save the value.