Fresenius Medical Care 2008T Operator's Manual page 27

Select ...
Or
Specific information regarding each treatment screen can be found in Chapter 3, "Setting
Treatment Parameters" and Chapter 4, "Monitoring the Treatment."
2008T Machine Operator's Manual P/N 490122 Rev N
To ...
View and select acid/bicarbonate concentrate type, bicarbonate,
sodium, electrolyte concentrations, and conductivity settings.
View Pressure test, Alarm test, and Diasafe test options and results.
View treatment options for single needle patients, high flux dialyzers,
patient ID numbers, and dialysate sampling.
View options for administering heparin gradually over the course of the
treatment and/or as a bolus injection.
View estimate of treatment effectiveness based on the actual dialyzer
clearance.
View the Access Flow messages and data
View arterial and venous blood temperature data with machines
equipped with the optional Blood Temperature Module. For more
information, see Blood Temperature Monitor Operating Instructions
(P/N 470164).
View the relative blood volume data and trends with machines
equipped with the optional Blood Volume Module. For more
information, see Blood Volume Monitor Operating Instructions (P/N
490041).
When the Crit-Line in a Clip (CLiC) device is used during the
treatment, the "Crit-Line" screen replaces the "BTM BVM" screen. The
"Crit-Line" screen can be configured (in Service Mode) to show either
blood volume or hematocrit. Additionally, the "Crit-Line" screen can
alternately display blood pressure or oxygen saturation graphs during
the treatment. Most of the commonly viewed data from other screens
are also grouped on the "Crit-Line" screen for convenient monitoring.
For more information, see the 2008T Hemodialysis Machine with CLiC
User's Guide (P/N 490206).
View all pulse and blood pressure test results taken during treatment.
Blood pressure alarm limits and inflation pressure and frequency of
blood pressure tests are set in this screen.
Chapter 1—Overview
27