Monitoring The Hemodialysis Treatment From The “Crit-Line” Screen - Fresenius Medical Care 2008T Operator's Manual

Chapter 4—Monitoring the Treatment
Monitoring the hemodialysis treatment from the "Crit-Line"
screen
Most of the commonly viewed data from other screens are grouped on the "Crit-Line" screen
for convenient monitoring. Listed below are the features of the "Crit-Line" screen that can
also be found on other screens.
Table 30 – Crit-Line Screen Features Found on Other Screens
Feature
Art Press
Ven Press
TMP
UF Goal
UF Rate
UF Rmvd
Dial Flow
Temp
Cond
Blood Flow
Hep Rate
Kecn
124
Description
Arterial Pressure – The value displayed on the "Home" screen (mmHg)
Venous Pressure – The value displayed on the "Home" screen (mmHg)
TMP (Transmembrane Pressure) – The value displayed on the "Home"
screen (mmHg)
UF Goal – The UF goal selected for the treatment and set on the "Home"
screen (ml)
UF Rate – The UF rate selected for the treatment and set on the "Home"
screen (ml/h)
UF Removed – The UF removed at a given point in the treatment and
displayed on the "Home" screen (ml)
Dialysate Flow – The dialysate flow rate selected for the treatment and set on
the "Home" screen (ml/min). The dialysate flow rate can also be turned on or
off from the "Dialysate" screen.
Temperature – The temperature of the dialysate as displayed on the "Home"
screen (°C)
Conductivity – The conductivity of the dialysate as displayed on the "Home"
screen (mS/cm)
Blood Flow Rate – The current blood pump rate (ml/min)
Heparin Rate – The heparin pump rate set on the "Heparin" screen (ml/h)
Note: As on the "Heparin" screen, this value will flash when the heparin pump
is off unless both the "Heparin" screen Rate and Infusion Time buttons are
set to 0 (zero).
Kecn – The current Kecn (amount of sodium clearance) measurement. The
Kecn is also displayed on the "Kt/V AF" screen's "OLC Data" subscreen.
Treatment (Tx) Clock – This button runs or pauses the treatment and displays
the Remaining Time of Dialysis (RTD). The green segment of the pie chart
represents the amount of treatment completed and grows as the treatment
progresses. The Tx Clock button and an RTD button to set the RTD are also
located on the "Home" screen.
2008T Machine Operator's Manual P/N 490122 Rev N