Blood Pump Failure - Fresenius Medical Care 2008T Operator's Manual

176 Troubleshooting
Blood Pump -12 V Error - 12 volts is outside the allowable
range
Blood Pump +24 V Error + 24 volts is outside the allowable
range
Blood Pump Button Alarm Key stuck or held in too long
Blood Pump Calib Alarm Pressure was adjusted too much in
calibration mode
Blood Pump Direction Pump is turning in the wrong direction
Error
Blood Pump EEPROM EEPROM error
Err
Blood Pump EPROM EPROM CRC error
Error
Blood Pump Erasing Error erasing Flash ROM while in
Error Service Mode

Blood Pump Failure

Electronic self-test failure.
Blood Pump Flash Error
Error copying data into Flash ROM
while in Service Mode
Blood Pump RAM Error RAM check error
Blood Pump Rate Alarm Pump is not reaching speed at
maximum voltage
Blood Pump ROM Error Flash ROM CRC error
Blood Pump Stop Alarm Pump rotor turning when it should not
be
2008T Machine Operator's Manual P/N 490122 Rev N
Alarm See message E.09
Alarm See message E.08
Alarm See message A.16
Alarm See message A.26
Alarm See message A.13
Alarm See message E.05
Alarm See message E.01
Alarm See message E.98
Alarm Turn machine power off and back on. If alarm does not clear, return
the blood to the patient if alarm occurs during treatment. Take the
machine out of service and alert a qualified service technician.
Alarm See message E.97
Alarm See message E.03
Alarm See message A.11
Alarm See message E.02
Alarm See message A.29