Resetting, Try Again; Reverse Bloodlines; Rtd = Zero; Run Access Flow? - Fresenius Medical Care 2008T Operator's Manual

206 Troubleshooting

Resetting, Try Again.

Blood pressure module resetting
Retry > Press = XXX The cuff pressure is too low to
measure the blood pressure. The cuff
pressure is XXX mmHg.

Reverse bloodlines

This message is a prompt for the
operator reverse the bloodlines for the
Access Flow test
Rinse Cond High The Reverse Osmosis (RO) water
inlet conductivity is too high.
RO Water Cond High The Reverse Osmosis (RO) water
inlet conductivity is too high.

RTD = Zero

The RTD (Remaining Time on
Dialysis) clock has counted down to
zero.
Running Diasafe Test This message is advising the operator
of the status of the Diasafe test
Running Online PHT
This message is displayed when the
online Pressure Holding Test is in
progress.

Run Access Flow?

This message is a prompt for the
operator begin the Access Flow test.
Select Concentrate This message is a prompt for the
operator to select a concentrate.
Select new goal or rate UF time is out of range.
2008T Machine Operator's Manual P/N 490122 Rev N
Warning Wait until blood pressure module completes resetting and retry blood
pressure reading.
Dialog No action necessary
Message
Warning To proceed with the Access Flow test, reverse the bloodlines and
press CONFIRM.
Opening Press the RESET key to clear the message. Perform a Rinse cycle. If
Screen alarm is not cleared, take the machine out of service and alert a
Message qualified service technician.
Opening Press the RESET key to clear the message. Perform a Rinse cycle. If
Screen alarm is not cleared, take the machine out of service and alert a
Message qualified service technician.
Warning Reset the alarm. This message has alerted the operator that the
preset time on dialysis has elapsed (RTD = 0:00). If prescribed
treatment time has not been completed, the operator must take
further action to comply with the prescribed treatment.
Advisory Advisory only. No action is required.
Advisory Advisory only. No action is required.
Warning To proceed now, press CONFIRM. To delay, press Escape. To
cancel, go to the "Kt/V AF" screen and toggle the Access Flow check
box to Off.
Advisory To select a concentrate from the menu, use the  or  (Up/Down)
keys on the Keyboard to highlight the desired concentrate, and press
CONFIRM. For more information, see Chapter 3, "Setting an
Acid/Bicarbonate Type."
Dialog Enter a new UF Goal or reduce UF time.
Message