Exit Remote Diagnostics - Siemens SINUMERIK 840D sl Operating Manual

Alarm, error and system messages
15.9 Remote diagnostics
Access via modem must be enabled if the access is to be made possible via a modem.
When requesting remote diagnostics, you obtain a window with the corresponding pre-
assigned data and values of the ping service. If required, you can ask your machine
manufacturer for this data.
Data
IP address
Port
Send duration Duration of the request in minutes
Send interval
Ping send da‐
ta
Procedure
References
SINUMERIK Operate Commissioning Manual
15.9.4

Exit remote diagnostics

Procedure
770
Machine manufacturer
Please refer to the machine manufacturer's instructions.
Meaning
IP address of the remote PC
Standard port that is intended for remote diagnostics
Cycle in which the message is sent to the remote PC in seconds
Message for the remote PC
1. The "Remote diagnostics (RCS)" window is opened.
2. Press the "Request remote diagnostics" softkey.
The "Request remote diagnostics" window is displayed.
3. Press the "Change" softkey if you would like to edit the values.
4. Press the "OK" softkey.
The request is sent to the remote PC.
1. The "Remote diagnostics (RCS)" is opened and it is possible that remote
monitoring or remote access is active.
2. Block the modem access if access via modem is to be blocked.
- OR -
In the "Remote Diagnostics (RCS)" window, reset the access rights to
"Permit no remote access".
Operating Manual, 05/2017, A5E40868721
Turning