Siemens SINUMERIK 840D sl Operating Manual page 849

Display
Status
Procedure
Turning
Operating Manual, 05/2017, A5E40868721
Meaning
Display of the current status of a maintenance task.
The maintenance task has been started.
The maintenance task is completed.
The maintenance task is deactivated, i.e. the time has been
stopped.
The status cannot be edited.
1. Select the "Diagnostics" operating area.
2. Press the menu forward key and then the "Service planner" softkey.
The window opens and displays a list of all the tasks that have been set
up.
The values cannot be edited.
3. Press the "New maintenance task" softkey to set up a new maintenance
task.
A message informs you that a new maintenance task will be set up at the
next free position. Enter the required data in the columns and press the
"OK" softkey.
- OR -
Position the cursor on the desired maintenance task and press the
"Change task" softkey to change the associated times.
All columns except Remaining time and Status can be edited.
- OR -
Press the "Reset all" softkey to reset all the times.
- OR -
Position the cursor on the desired maintenance task and press the "De‐
lete task" softkey to remove the maintenance task from the list.
Service Planner (828D only)
25.2 Set maintenance tasks
849