Siemens SINUMERIK 840D sl Operating Manual page 125

Highlighting of selected G code commands or keywords
In the program editor settings, you can specify whether selected G code commands are to be
highlighted in color. The following colors are used as standard:
Display
Blue font
Red font
Green font
Blue-green font
Gray font
Editing a program directly
In the Reset state, you can edit the current program directly.
See also
Setting for automatic mode (Page 192)
Turning
Operating Manual, 05/2017, A5E40868721
Meaning
D, S, F, T, M and H functions
"G0" motion command
"G1" motion command
"G2" or "G3" motion command
Comment
Machine manufacturer
You can define further highlight colors in the "sleditorwidget.ini" configuration file.
Please refer to the machine manufacturer's instructions.
1. Press the <INSERT> key.
2. Place the cursor at the relevant position and edit the program block.
Direct editing is only possible for G code blocks in the NC memory, not
for external execution.
3. Press the <INSERT> key to exit the program and the edit mode again.
Machining the workpiece
6.4 Displaying the current program block
125