Parameters
The parameters of the input screen forms correspond to the parameters under Automatic (see
Section Contour turning (Page 383)).
Last contour
16.6.4
Milling with Manual Machine
The same range of technological functions (cycles) is available as in automatic mode for the
milling of simple geometric shapes.
Turning
Operating Manual, 05/2017, A5E40868721
If you have created a contour since the startup of the machine, the "Last contour"
softkey is available. You then have the option to reopen the input screen with
the last contour you entered in "Manual machine" for editing.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
⇒
Working with Manual Machine
16.6 More complex machining
⇒
⇒
⇒
783