Starting The Mold Making View; Adapting The Mold Making View - Siemens SINUMERIK 840D sl Operating Manual

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

6.15.1

Starting the mold making view

Procedure
6.15.2

Adapting the mold making view

You can adapt the graphic in various ways to better assess the workpiece in the mold making
view.
Preconditions
● The required program is opened in the mold making view.
● The "Graphic" softkey is active.
Procedure
Turning
Operating Manual, 05/2017, A5E40868721
1.
Select the "Program manager" operating area.
2.
Select the program that you would like to display in the mold making view.
3.
Press the "Open" softkey.
The program is opened in the editor.
4.
Press the ">>" and "Mold making view" softkeys.
The editor splits up into two areas.
The G code blocks are displayed in the left half of the editor.
The workpiece is displayed in the mold making view on the right-hand
side of the editor. All of the points and paths programmed in the part
program are represented.
1.
Press the softkey "Hide G1/G2/G3" if you want to conceal the machining
paths.
- OR -
2.
Press the softkey "Hide G0" if you want to deactivate the approach and
retraction paths.
- OR -
Press softkey "Hide points" to conceal all the points in the graphic.
Machining the workpiece
6.15 Mold making view
185

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d

Table of Contents