Selecting A Block; Deleting A Block - Siemens SINUMERIK 840D sl Operating Manual

19.6

Selecting a block

You have the option of setting the interrupt pointer to the current cursor position. The next time
the program is started, processing will resume from this point.
With teach-in, you can also change program areas that have already been executed. This
automatically disables program processing.
You must press reset or select a block to resume the program.
Requirement
The program to be processed is selected.
Proceed as follows
19.7

Deleting a block

You have the option of deleting a program block entirely.
Requirement
"AUTO" mode: The program to be processed is selected.
Turning
Operating Manual, 05/2017, A5E40868721
1. Select the "Machine" operating area.
2. Press the <AUTO> key.
3. Press the <TEACH IN> key.
4. Press the "Teach prog." softkey.
5. Place the cursor on the desired program block.
6. Press the "Block selection" softkey.
Teaching in a program
19.7 Deleting a block
807