Siemens SINUMERIK 840D sl Operating Manual page 397

Figure 10-4
Figure 10-5
Requirement
For a G code program, at least one CYCLE62 is required before CYCLE952.
If CYCLE62 is only present once, then this involves the finished part contour.
If CYCLE62 is present twice, then the first call is the blank contour and the second call is the
finished-part contour (see also Section "Programming (Page 383)").
Note
Execution from external media
If you execute programs from an external drive (e.g. local drive or network drive), you require
the "Execution from external storage (EES)" function.
For additional information, please refer to the following documentation:
SINUMERIK Operate Commissioning Manual
Rule
With the "Execution from External Storage (EES)" function, you have the option to access any
logical drive with part programs – and to directly process them as if through the NC program
memory.
Turning
Operating Manual, 05/2017, A5E40868721
α > 1: Boundary between unmachined and finished parts at the top
α ≤ 1°: Boundary between unmachined and finished parts at the side
Programming technology functions (cycles)
10.3 Contour turning
397