Displaying Simulation Alarms - Siemens SINUMERIK 840D sl Operating Manual

Procedure
...
7.10

Displaying simulation alarms

Alarms might occur during simulation. If an alarm occurs during a simulation run, a window
opens in the operating window to display it.
The alarm overview contains the following information:
● Date and time
● Deletion criterion
Specifies with which softkey the alarm is acknowledged
● Alarm number
● Alarm text
Precondition
Simulation is running and an alarm is active.
Procedure
Turning
Operating Manual, 05/2017, A5E40868721
1. Press the "Details" softkey.
2. Press the "Cut" softkey.
The workpiece is displayed in the cut state.
3. Press the corresponding softkey to shift the cutting plane in the required
direction.
1. Press the "Program control" and "Alarm" softkeys.
The "Simulation Alarms" window is opened and a list of all pending alarms
is displayed.
Press the "Acknowledge alarm" softkey to reset the simulation alarms
indicated by the Reset or Cancel symbol.
The simulation can be continued.
- OR -
Press the "Simulation Power On" softkey to reset a simulation alarm in‐
dicated by the Power On symbol.
Simulating machining
7.10 Displaying simulation alarms
213