Siemens SINUMERIK 840D sl Operating Manual page 277

6. Solid machine residual material
Turning
Operating Manual, 05/2017, A5E40868721
Position
Machining direction
D 4.000inc
Cutting depth
UX 0.4inc
UZ 0.2inc
DI
BL Cylinder
XD
ZD
Relief cuts
Set machining
area limits
4. Press the "Accept" softkey.
If a blank programmed under "CONT_1" is used, under parameter "BL",
the "Contour" blank description should be selected instead of "Cylinder".
When selecting "Cylinder", the workpiece is cut from the solid material.
Stock removal contour
1. Press the "Cont. turn." and "St. remov. resid." softkeys.
The "Stock removal residual material" input window opens.
2. Enter the following technology parameters:
9.18 Example: Standard machining
outside
(from the face to the rear side)
0
0inc
0inc
No
No
Creating a ShopTurn program
277