Measuring The Workpiece Zero - Siemens SINUMERIK 840D sl Operating Manual

Procedure
...
4.8.7

Measuring the workpiece zero

Procedure
Turning
Operating Manual, 05/2017, A5E40868721
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
3. Press the "Overview", "Basis" or "G54...G599" softkey.
4. Press the "Details" softkey.
5. Position the cursor on the work offset you would like to delete.
6. Press the "Clear offset" softkey.
A confirmation prompt is displayed as to whether you really want to delete
the work offset.
7. Press the "OK" softkey to confirm that you wish to delete the work offset.
1. Select the "Parameters" operating area and press the "Zero offset" soft‐
key.
2. Press the "G54...G599" softkey and select the zero offset in which the
zero point is to be saved.
3. Press the "Workpiece zero" softkey.
You change to the "Set Edge" window in the "JOG" mode.
4. Traverse the tool in the Z direction and scratch it.
5. Enter the position setpoint of the workpiece edge Z0 and press the "Set
ZO" softkey.
Setting up the machine
4.8 Zero offsets
95