Tool List - Siemens SINUMERIK 840D sl Operating Manual

Figure 13-15 Tap (Type 240)
Figure 13-16 3D probe
Note
A 3D probe must be calibrated before use.
13.5

Tool list

All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the replacement tool number.
Turning
Operating Manual, 05/2017, A5E40868721
Machine manufacturer
The tool length is measured to the center of the ball or to the ball circumference.
Please refer to the machine manufacturer's specifications.
Tool management
13.5 Tool list
659