Reactivating The Multitool - Siemens SINUMERIK 840D sl Operating Manual

Unloading a multitool
13.15.7

Reactivating the multitool

Multitool and tools located on the multitool can be disabled independently of one another.
If a multitool is disabled, then the tools of the multitool can no longer be changed in using a
tool change.
If only one tool on a multitool has a set monitoring function and the lifetime or the unit quantity
has expired, then the tool and the multitool on which the tool is located are disabled. The other
tools on the multitool are not disabled.
If several tools with monitoring are mounted on the multitool and the lifetime or unit quantity
has expired for one tool, then only this tool is disabled.
Reactivating
If a tool with expired lifetime or unit quantity that is mounted on a multitool is reactivated, then
for this tool, the lifetime/unit quantity is set to the setpoint and the tool and the multitool are re-
enabled (disable status is removed).
If a multitool is reactivated, on which tools with monitoring are mounted, then the lifetime/unit
quantity for all tools on the multitool are set to the setpoint no matter whether the tools are
disabled or not.
Requirements
In order to reactivate a tool, the monitoring function must be activated and a setpoint must be
stored.
Turning
Operating Manual, 05/2017, A5E40868721
2. Position the cursor on the multitool that you wish to unload from
the magazine.
3. Press the "Unload" softkey.
The multitool is removed from the magazine and is saved in the
NC memory at the end of the tool list.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Tool management
13.15 Working with multitool
699