Program Control During The Simulation; Changing The Feedrate - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining

7.8 Program control during the simulation

Procedure
7.8 Program control during the simulation
7.8.1

Changing the feedrate

You have the capability of changing the feedrate at any time during the simulation.
You track the changes in the status bar.
Note
If you are working with the "Simultaneous recording" function, you use the rotary switch
(override) on the control panel.
Procedure
208
1. The simulation or the simultaneous recording is started.
2. Press the ">>" softkey.
The tool paths are displayed in the active view.
3. Press the softkey to hide the tool paths.
The tool paths are still generated in the background and can be shown
again by pressing the softkey again.
4. Press the "'Delete tool path" softkey.
All of the tool paths recorded up until now are deleted.
1. Simulation is started.
2. Press the "Program control" softkey.
3. Press the "Override +" or "Override -" softkey to increase or decrease the
feedrate by 5%, respectively.
- OR -
Press the "100% override" softkey to set the feedrate to 100%.
- OR -
Press the "<<" softkey to return to the main screen and perform the sim‐
ulation with changed feedrate.
Operating Manual, 05/2017, A5E40868721
Turning