Siemens SINUMERIK 840D sl Operating Manual page 833

Predefined energy-saving profiles
Energy-saving profile
Simple energy-saving mode
(machine standby)
Full energy-saving mode (NC
standby)
Maximum energy-saving
mode (auto shut-off)
References
Information on the configuration of the energy-saving profiles is provided in the following
reference:
System Manual "Ctrl-Energy", SINUMERIK 840D sl / 828D
Procedure
Turning
Operating Manual, 05/2017, A5E40868721
Meaning
Machine units that are not required are either throttled or shut down.
When required, the machine is immediately ready to operate again.
Machine units that are not required are either throttled or shut down.
Wait times are incurred at the transition into the ready to operate state.
The machine is completely switched-off.
Longer wait times are incurred at the transition into the ready to operate
state.
Machine manufacturer
The selection and function of the displayed energy-saving profiles can differ.
Please observe the information provided by the machine manufacturer.
1. Select the "Parameter" operating area.
2. Press the menu forward key and then the "Ctrl-Energy" softkey.
- OR -
Press the <CTRL> + <E> keys.
+
3. Press the "Ctrl-E profile" softkey.
The "Ctrl-E Profile" window opens.
4. Position the cursor on the required energy-saving profile and press the
"Activate immediately" softkey if you wish to directly activate this state.
Ctrl-Energy
22.3 Ctrl-E profiles
833