Siemens SINUMERIK 840D sl Operating Manual page 477

Parameters in the "Input complete" mode
Parameters, G code program
Input
PL Machining plane
Milling direction
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter Description
Machining
● Face C
surface
● Face Y
● Peripheral surface C
● Peripheral surface Y
(only for Shop‐
Turn)
Position
● At the front (face)
● At the rear (face)
● Outside (peripheral surface)
(only for Shop‐
● Inside (peripheral surface)
Turn)
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for Shop‐
Turn)
Machining
● ∇ (roughing)
● ∇∇∇ (finishing)
● ∇∇∇ edge (edge finishing)
● Chamfering
FZ (only for G Depth infeed rate
code)
Circular pattern
● Full circle
The circumferential slots are positioned around a full circle. The distance from one
circumferential slot to the next circumferential slot is always the same and is
calculated by the control.
● Pitch circle
The circumferential slots are positioned around a pitch circle. The distance from one
circumferential slot to the next circumferential slot can be defined using angle α2.
Turning
Operating Manual, 05/2017, A5E40868721
Parameters, ShopTurn program
● Complete
T
D
mm F
mm S / V
*
Programming technology functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting
rate
10.4 Milling
mm/min
mm/tooth
rpm
m/min
Unit
*
477