Siemens SINUMERIK 840D sl Operating Manual page 218

Creating a G code program
8.2 Program views
Parameter screen with help display
Note
Switching between the help screen and the graphic view
The key combination <CTRL> + <G> is also available for the switchover between the help
screen and the graphic view.
Figure 8-2
The animated help displays are always displayed with the correct orientation to the selected
coordinate system. The parameters are dynamically displayed in the graphic. The selected
parameter is displayed highlighted in the graphic.
218
In the program view, you can move between the program blocks by
pressing the <Cursor up> and <Cursor down> keys.
Press the <Cursor right> key to open a selected program block or cycle
in the program view.
The associated parameter screen with help display is then displayed.
Parameter screen with help display
Operating Manual, 05/2017, A5E40868721
Turning