Creating a ShopTurn program
9.18 Example: Standard machining
Parameters
F4
X4
Z4
F5
X5
Z5
F6
X6
Z6
9.17
Measuring cycle support
Measuring cycles are general subroutines designed to solve specific measurement tasks. They
can be adapted to specific problems via parameter settings.
References
You will find a more detailed description on how to use measuring cycles in:
Programming Manual Measuring cycles / SINUMERIK 840D sl/828D
9.18
Example: Standard machining
General information
The following example is described in detail as ShopTurn program. A G code program is
generated in the same way; however, some differences must be observed.
If you copy the G code program listed below, read it into the control and open it in the editor,
then you can track the individual program steps.
270
Description
Feedrate for approach to the fourth position
Alternatively, rapid traverse
4. position ∅ (abs) or 4th position (inc)
4. position (abs or inc)
Feedrate to approach the fifth position
Alternatively, rapid traverse
5. position ∅ (abs) or 5th position (inc)
5. position (abs or inc)
Feedrate to approach the sixth position
Alternatively, rapid traverse
6. position ∅ (abs) or 6th position (inc)
6. position (abs or inc)
Software option
You require the "Measuring cycles" option to use "Measuring cycles".
Machine manufacturer
Under all circumstances, observe the machine manufacturer's instructions.
Unit
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
Operating Manual, 05/2017, A5E40868721
Turning