Siemens SINUMERIK 840D sl Operating Manual page 471

Parameter Description
EW Maximum insertion angle – (for insertion with oscillation only)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter Description
Machining ● Face C
surface
● Face Y
● Peripheral surface C
● Peripheral surface Y
Position
● At the front (face)
(only for ShopTurn)
● At the rear (face)
● Outside (peripheral surface)
● Inside (peripheral surface)
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for ShopTurn)
Machining The following machining operations can be selected:
● ∇ (roughing)
● ∇∇∇ (finishing)
● ∇∇∇ edge (edge finishing)
● Chamfering
The positions refer to the reference point:
X0 Reference point X
Y0 Reference point Y
Z0 Reference point Z
(only for G code)
Turning
Operating Manual, 05/2017, A5E40868721
● simple
mm
*
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
10.4 Milling
Unit
Degrees
mm
mm
mm/min
mm/rev
rpm
m/min
mm
mm
mm
471