Reactivate Tool - Siemens SINUMERIK 840D sl Operating Manual

Icon/
Marking
Green double arrow
Gray double arrow (con‐
figurable)
Red "X"
Procedure
See also
Displaying tool details (Page 683)
Changing the cutting edge position or tool type (Page 691)
13.6.1

Reactivate tool

You can replace disabled tools or make them ready for use again.
Preconditions
In order to be able to reactivate a tool, the monitoring function must be activated and a setpoint
must be stored.
Procedure
Turning
Operating Manual, 05/2017, A5E40868721
1. Select the "Parameter" operating area.
2. Press the "Tool wear" softkey.
1. The tool wear list is opened.
2. Position the cursor on the disabled tool which you would like to reuse.
3. Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life or work‐
piece count.
The disabling of the tool is cancelled.
Meaning
The magazine location is positioned at the change position.
The magazine location is positioned at the loading position.
The magazine location is disabled.
Tool management
13.6 Tool wear
677