Changing The Cutting Edge Position Or Tool Type; Settings For Tool Lists - Siemens SINUMERIK 840D sl Operating Manual

13.13

Changing the cutting edge position or tool type

Procedure
...
13.14

Settings for tool lists

In the "Settings" window you have the following options to set the view in the tool lists:
● Display only one magazine in "Magazine sort"
– You can limit the display to one magazine. The magazine is displayed with the assigned
– You may set via a configuration if you want to jump to the next magazine by clicking
● Display only spindle in buffer.
In order to display only the spindle location during operation, the remaining locations of the
buffer are hidden.
Turning
Operating Manual, 05/2017, A5E40868721
1. The tool list, the wear list, the OEM tool list or the magazine is opened.
2. Position the cursor in the column "Type" of the tool that you wish to
change.
3. Press the <SELECT> key.
The "Tool types - Favorites" window opens.
4 Press the <Cursor right> or <Cursor left> key to select the new cutting
edge position.
- OR -
Select the required tool type in the list of favorites or select using softkeys
"Cutters 100-199", "Drills 200-299", "Cutting tools 500-599" or "Special
tools 700-900".
5. Press the "OK" softkey.
The new cutting edge position or the new tool type is accepted and the
corresponding icon is displayed in the "Type" column.
buffer magazine locations and the tools not loaded.
softkey "Magazine selection" or if the dialog "Magazine selection" is switched over to
any magazine.
Tool management
13.14 Settings for tool lists
691