Multi-channel machining
11.2 Multi-channel support
Modify blank
Parameter
Description
Data for
Here, you specify the spindle selected for the blank.
● Main spindle
● Counterspindle
Blank
The following blanks can be selected:
● Tube
● Cylinder
● Polygon
● Centered cuboid
● Delete
W
Width of the blank - (only for centered cuboid)
L
Length of the blank - (only for centered cuboid)
N
Number of edges – (only for polygon)
SW or L
Width across flats or edge length – (only for polygon)
ZA
Initial dimension
ZI
Final dimension (abs) or final dimension in relation to ZA (inc)
ZB
Machining dimension (abs) or machining dimension in relation to ZA (inc)
XA
Outside diameter – (only for tube and cylinder)
XI
Inside diameter (abs) or wall thickness (inc) – for tube only
Procedure
612
1.
The double editor is opened and the cursor is positioned in the G
code program.
2.
Press the "Misc." and "Blank" softkeys.
The "Blank Input" window opens.
3.
Select the desired blank and enter the corresponding values.
4.
Press the "Accept" softkey.
Operating Manual, 05/2017, A5E40868721
Unit
mm
mm
mm
mm
Turning