Siemens SINUMERIK 840D sl Operating Manual page 643

Parameters
Coordinate
system
XP
ZP
Flush chuck
DIR
S
α1
Z1
ZR
FR
Fixed
stop
Complete transfer
function
Withdraw blank
F
Cutting-off
cycle
Complete transfer
function
Turning
Operating Manual, 05/2017, A5E40868721
Description
● MCS
The park position is specified in the machine coordinate system. Teaching in
the park position and angular offset is only possible in the machine coordinate
system.
● WCS
The park position is specified in the workpiece coordinate system.
Park position of tool in X direction (abs)
Park position of tool in Z direction (abs)
Flush counter-spindle chuck
● Yes
● No
Direction of rotation
● Spindle rotates clockwise
● Spindle rotates counter-clockwise
● Spindle does not rotate
Spindle speed – (only when the spindle rotates)
Angular offset
Transfer position (abs.)
Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
Reduced feedrate
Travel to fixed stop
● Yes
The counter-spindle stops at a defined distance away from transfer position
Z1 and then traverses with a defined feedrate up to the fixed stop.
● No
The counter-spindle traverses to the transfer position Z1.
Withdrawing
Withdraw complete blank:
● Yes
● No
Feed (only when "yes" for "withdraw blank")
Cutting-off cycle in the following block
● Yes
● No
Rear side (for main spindle in counter-spindle)
Multi-channel machining
11.2 Multi-channel support
Unit
mm
mm
rev/min
Degrees
mm/rev
mm/min
643