Procedure
See also
Displaying tool details (Page 683)
Changing the cutting edge position or tool type (Page 691)
13.5.1
Additional data
The following tool types require geometry data that is not included in the tool list display.
Tool types with additional geometry data
Tool type
111 Conical ballhead cutter
121 End mill with corner rounding Corner radius
130 Angle head cutter
131 Angle head cutter with cor‐
ner rounding
140 Face milling
155 Bevel cutter
156 Bevel cutter with corner
rounding
Turning
Operating Manual, 05/2017, A5E40868721
1.
Select the "Parameter" operating area.
2.
Press the "Tool list" softkey.
The "Tool List" window opens.
Additional parameters
Corner radius
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
V (direction vector 1 - 6)
Vector X, vector Y, vector Z
Geometry length (length X, length Y, length Z)
Corner radius
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
V (direction vector 1 - 6)
Vector X, vector Y, vector Z
External radius
Tool angle
Taper angle
Corner radius
Taper angle
Tool management
13.5 Tool list
663