Assigning The Machining Plane - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
6.11 Working with DXF files
Procedure
6.11.3.3

Assigning the machining plane

You can select the machining plane in which the contour created with the DXF reader should
be located.
Procedure
158
1. The DXF file is opened in the editor.
2. Press the ">>" and "Specify reference point" softkeys.
3. Press the "Element start" softkey to place the zero point at the start of the
selected element.
- OR -
Press the "Element center" softkey to place the zero point at the center
of the selected element.
- OR -
Press the "Element end" softkey to place the zero point at the end of the
selected element.
- OR -
Press the "Arc center" softkey to place the zero point at the center of an
arc.
- OR -
Press the "Cursor" softkey to define the zero point at any cursor position.
- OR -
Press the "Free input" softkey to open the "Reference Point Input" window
and enter the values for the positions (X, Y) there.
1. The DXF file is opened in the editor.
2. Press the "Select plane" softkey.
The "Select Plane" window opens.
3. Select the desired plane and press the "OK" softkey.
Operating Manual, 05/2017, A5E40868721
Turning