Siemens SINUMERIK 840D sl Operating Manual page 41

The ENS coordinate system corresponds to the Work coordinate system, reduced by certain
components ($P_TRAFRAME, $P_PFRAME, $P_ISO4FRAME, $P_CYCFRAME), which are
set by the system when machining and are then reset again. By using the ENS coordinate
system, jumps into the actual value display are avoided that would otherwise be caused by
the additional components.
Maximize display
Display overview
Display
Header columns
Work/Machine
Position
Display of distance-to-go
Feed/override
Repos offset
Collision monitoring
(only 840D sl)
Footer
See also
Zero offsets (Page 88)
Turning
Operating Manual, 05/2017, A5E40868721
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Press the ">>" and "Zoom act. val." softkeys.
Meaning
Display of axes in selected coordinate system.
Position of displayed axes.
The distance-to-go for the current NC block is displayed while the
program is running.
The feed acting on the axes, as well as the override, are displayed
in the full-screen version.
The distances traversed in manual mode are displayed.
This information is only displayed when you are in the "Repos" sub‐
mode.
Collision avoidance is activated for the JOG and MDA or
AUTOMATIC modes.
Note:
The $MN_JOG_MODE_MASK machine data can be set
to suppress the display of the symbol.
Please refer to the machine manufacturer's specifications.
Collision avoidance is deactivated for the JOG and MDA
or AUTOMATIC modes.
Display of active work offsets and transformations.
The T, F, S values are also displayed in the full-screen version.
Introduction
2.4 User interface
41