Siemens SINUMERIK 840D sl Operating Manual page 116

Working in manual mode
5.6 Simple stock removal of workpiece
Table 5-1
Parameter
T
D
F
S / V
Spindle M function
Machining
Position
Machining
direction
X0
Z0
X1
Z1
FS1...FS3 or R1...R3
XF2
D
UX
UZ
116
5. Press the "OK" softkey.
The parameter screen is closed.
6. Press the <CYCLE START> key.
The "Stock removal" cycle is started.
You can return to the parameter screen form at any time to check and
correct the inputs.
Description
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting rate
Direction of spindle rotation (only when ShopTurn is not active)
●
●
● ∇ (roughing)
● ∇∇∇ (finishing)
Machining position
● Face
● Longitudinal
Reference point ∅ (abs)
Reference point (abs)
End point X ∅ (abs) or end point X in relation to X0 (inc)
End point Z (abs) or end point Z in relation to X0 (inc)
Chamfer width (FS1...FS3) or rounding radius (R1...R3)
Undercut (alternative to FS2 or R2)
Infeed depth (inc) – (for roughing only)
Final machining allowance in X direction (inc) – (for roughing only)
Final machining allowance in Z direction (inc) – (for roughing only)
Unit
mm/rev
rpm
m/min
mm
mm
mm
mm
mm
mm
mm
mm
mm
Operating Manual, 05/2017, A5E40868721
Turning