Setting The Behavior Of Output Signals For Each Layout (Layout Settings); Changing Layout Numbers In The Main Window - Omron FH-1 series User Manual

Setting the Behavior of Output Signals for Each Layout (Layout Settings)

For each layout, you can set the behavior of output signals after the layout is changed.
1
Select [Layout setup] from the [Window] Menu for the main window for layout 0.
2
The following [Layout setup] dialog box is displayed.
Set the name for layouts 0 to 8, and whether to use the RUN signal output and external output signals.
Item
Layout
RUN signal output
Output

Changing Layout Numbers in the Main Window

You can change the layout in the Main Window to the layout number that was set in Layout Modification Mode.
Use this when you need to work with more than one layout.
1
Select [Switch layout] on the [Function] menu or from the tool buttons.
2
Select the layout number to change to and click the [OK] button to close the [Switch layout]
dialog box.
Item
Layout number
Note
It is also possible to switch the Layout number with a communication command.
98
Arranging Windows
Layout name (up to 32 characters)
The RUN signal for the layout is output if the check box is selected.
Select or clear the check boxes.
Set whether to output the execution results of Results Output processing units.
• ON: Data is output when a Results Output processing unit is executed in the
measurement flow during execution of a measurement.
• OFF: Data is not output even when a results output processing unit is executed in the
measurement flow for a measurement.
• No Control: The state of the outputs that were in effect before the layout was changed
are retained. If [Output] is selected immediately before the layout is changed, the
outputs stay ON, and if [Output] is not selected, the outputs stay OFF.
Layout number (layout 0 to layout 8)
Description
Description
Vision System FH/FZ5 Series
User's Manual (Z365)