Omron FH-1 series User Manual page 221

Note
When either the remote operation PC or the sensor controller is changed to Layout 8 by layout switching, operation
on the sensor controller will be possible during remote operation. Note the following when using this feature:
• Switch either the remote operation PC or the sensor controller to Layout 8 with layout switching, not both. If the
layouts of both are changed to Layout 8, operation on the sensor controller will not be possible during remote
operation and only normal remote operation can be executed.
• The layout can be changed to Layout 8 during remote operation. After changing to Layout 8 on the remote
operation PC, close the remotely operated dialog box on the sensor controller. Operation on the sensor controller
will be possible while remote operation continues. To exit remote operation from this state, exit the FZ_FH
Remote Operation Tool on the remote operation PC.
• In Layout 8, an error dialog is not shown when an error occurs and instead an error string appears in the Error
Pane. If an error occurs, check the error in the Error Pane.
• In Layout 8, only the panes below can be used in Layout Modification Mode. To use panes other than these, use
a layout other than Layout 8 and execute normal remote operation.
• Flow Display Pane
• Image Pane
• Judgment Pane
• Error Pane
Vision System FH/FZ5 Series
User's Manual (Z365)
Remotely operating the controller (Remote Operation)
4
219