Omron FH-1 series User Manual page 306

Executing Calibration
 Vision Master Calibration (Homing operation selection is Enable)
External device
1: Moves to the axis
Response that
movement is completed.
Repeats processing within
this frame until calibration
complete flag is ON.
Moves only each axis of next axis
movement amount when calibration
complete flag is OFF.
4: Moves only each axis of
Response that
movement is completed.
304
Alignment
PLC
position when
Calibration is started.
3: Measurement Command
• Next axis movement amount
(by each axis of external device)
• Calibration complete flag
next axis movement
amount
FH/FZ5
2: Clear the measurement
results.
Response that clear
processing is completed.
Outputs data
3.1: Measurement
Vision System FH/FZ5 Series
User's Manual (Z365)