Omron FH-1 series User Manual page 283

Note
• Normal (Fxxx Series Method)
With the [Normal (Fxxx series method)] communications method, the OK response timing in relation to
MEASURE commands is different from that of the [Normal] communications method.
Normal (Fxxx series method) communications method
MEASURE
Measurement result
OK
• OK Responses
With [Normal communications method], an OK response is returned when the Controller receives a command.
With [Normal (Fxxx series method)], an OK response is returned when command execution is completed.
Settings for Touch Panel Monitor
An exclusive touch screen monitor, Touch Panel Monitor is available for FH Sensor Controllers to confirm
images or to display menus for condition settings.
IMPORTANT
• The Touch Panel Monitor (FH-MT12) is used exclusively with the FH series Sensor Controllers.
It cannot be used with FZ5 series Sensor Controller.
• The Touch Panel Monitor (FH-MT12) is supported only by Ver. 5.32 or later versions of the FH series Sensor
Controller.
To wire the Touch Panel Monitor (FH-MT12) and an FH series Sensor Controller, a monitor cable for video input
and a touch panel cable for touch panel communication are required.
Normally, use a USB cable connection for the Touch Panel Monitor (FH-MT12).
USB connection
(Maximum cable length: 5 m)
FH-MT12
Analog RGB
Vision System FH/FZ5 Series
User's Manual (Z365)
Type B Touch Panel cable(USB): FH-VUAB
D-Sub Monitor cable: FH-VMDA
USB
Normal communications method
MEASURE
OK
Measurement result
Connect to the optional FH series
Sensor Controller' s USB port
Type A
DVI-A
DVI-I
FH series Sensor Controller
Setting the Operating Environment of the System
6
281