Omron FH-1 series User Manual page 50

Menu Sub Menu
Fan control
setting
Encoder
trigger
Other
setting
Network
drive
setting
*1: Only 4 languages are available. If loads the unsettable data, perform in English.
*2: Setting is disable.
*3: EtherCAT setting is disable.
*4: Multi-line Random-trigger Mode setting is disable. If set Multi-line Random-trigger mode, perform in Standard mode.
*5: Operation mode tab is not displayed.
*6: Parallel processing tub is not displayed.
*7: Depending on the number of camera port of Sensor Controller.
*8: Enable only STEP 0 to 2.
*9: Enable only STEP 0.
*10: Enable only DSA 0 to 2.
*11: Enable only DSA 0.
*12: Disable to set. RS-422 is not supported.
*13: Supported only the Sensor Controller has 2 port: FH--10, FH--20
*14: Enable to set only 1 Sensor Controller under network.
48
Checking the System Configuration
Tab Group Parameter
Low rotation/
High rotation
Use the encoder
trigger
Encoder input
type
Resolution
Count rotations
with pulse Z
Trigger signal:
Enable timing:
Pulse reset
timing:
Trigger
Pulse A 0 to 5:
setting
Support
backlashing
Trigger in
backlashing
S-Z
Sensor Controller's Model
FH series
FH-1000
series FH-L FZ5-1100
FH-3000 series series
series
*2 *2
No No Yes
*2
Yes No Yes
*2
Yes No Yes
*2
Yes No Yes
*2
Yes No Yes
*2
Yes No Yes
*2
Yes No Yes
*2
Yes No
Yes
*2
Yes No Yes
*2
Yes No Yes
*2
Yes No Yes
Yes Yes Yes
Vision System FH/FZ5 Series
FZ5 series
FZ-600 FZ5-L
series series
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*2
Yes No
*14 *14
User's Manual (Z365)