Omron FH-1 series User Manual page 284

Use an RS-232C cable connection in the following cases.
• The Touch Panel Monitor (FH-MT12) and the FH series Sensor Controller are more than 5 m apart.
• All the USB ports of the FH series Sensor Controller are used for other I/O connections, and thus there is no available
USB port for the Touch Panel Monitor (FH-MT12) connection.
RS-232C connection
(Maximum cable length: 10m)
Analog RGB
For monitor cable of video input or communication cable of Touch Panel, refer to the followings:

Connection cable for FH-MT12
Cable name
Monitor cable
Touch Panel cable
When connect the monitor cable, Sensor Controller recognizes Touch Panel Monitor automatically, and then
start to display.
Note
When use only monitor function of Touch Panel Monitor (FH-MT12), confirm the followings:
• You can use both FH series Sensor Controller and FZ5 series Sensor Controller.
• No limitation of software version of FH series/FZ5 series Sensor Controller.
• Not cable for Touch Panel Monitor, but only monitor cable for video.
1
Connect the Touch Panel Monitor to the FH series
Sensor Controller.
2
In the Main Window, click [Tool] - [System Settings]
- [Startup] - [Startup setting], then click
[Communication]
282
Setting the Operating Environment of the System
FH-MT12
D-Sub
RS-232C
Type
DVI-RGB converter cable
USB
RS-232
Monitor cable: FH-VMDA
RS-232C
Cable length
2 m FH-VMDA 2M
5 m FH-VMDA 5M
10 m FH-VMDA 10M
2 m FH-VUAB 2M
5 m FH-VUAB 5M
2 m XW2Z-200PP-1
5 m XW2Z-500PP-1
10 m XW2Z-010PP-1
FH series Sensor Controller
DVI-A
DVI-I
Model Minimum bend radius
36 mm
25 mm
59 mm
Vision System FH/FZ5 Series
User's Manual (Z365)