Omron FH-1 series User Manual page 332

Note
Basic selection flow
Does Measurement
object (workpiece)
rotate?
yes
Rotation range of
measurement
object (workpiece)
Search Speed
For processing items to perform search processing such as [Search] and [Classification], you can specify the
search processing speed by through the model parameter items "Stable", "Precise", and/or "Skipping angle". If
the value specified for "Stab." or "Prec." is small or if the value for "Skipping angle" is large, the processing
speed can be increased since the amount of information for the models will be decreased during the search. In
contrast, if the values specified for "Stab." or "Prec." are large or if the value for "Skipping angle" is small, the
processing speed is slow because search is performed without the amount of model information being reduced.
Specify appropriate values for "Stable", "Precise", and "Skipping angle" according to the measurement
conditions.
Value for "Staple" / "Precise": Small
Value for "Skipping angle"
Measurement time: Short
Measurement precision: Low
330
Measurement Mechanism
No rotation (CR)
no
Rotation (PT)
narrow
Rotation (CR)
All
: Large
Value for "Staple" / "Precise": Large
Value for "Skipping angle" : Small
Measurement time: Long
Measurement precision: High
Vision System FH/FZ5 Series
User's Manual (Z365)