How To Start - Omron FH-1 series User Manual

How to Start

1
From the Start button located in the lower left area of the window of the remote operation PC,
select [Start] − [All Programs] − [OMRON] − [FZ_FH Simulator] and then select and launch
[FZ_FH Remote Operation Tool].
Note that a window that can be measured must be displayed on the Sensor Controller.
IMPORTANT
Do not connect or disconnect [FZ_FH Remote Operation Tool] when a measurement is being performed or
the system is running.
2
In the dialog box displayed by [FH-
RemoteOperator], select or directly enter
the IP address and the "Line No" of the
Controller to be connected. Press [Browse]
to find the IP address and the line number
of the Controller that can be connected.
* The "Line No" selected here is one of the following based on the system's operation mode.
Standard
Double Speed Multi-input
Non-stop adjustment
Multi-line random trigger
The Sensor Controller cannot be connected if a line number other than above is specified.
*1: The FZ5-1100 series Sensor Controller always has two lines (lines 0 and 1), and the FH series Sensor Controller allows
you to select as many as eight lines. Set the line numbers based on the number of lines that are set for the Sensor
Controller.
Vision System FH/FZ5 Series
User's Manual (Z365)
Operation mode
Measurement window
Non-stop adjustment window
Line 0 side
Line 1 side
Line 2 side
Line 3 side
*1
Line 4 side
Line 5 side
Line 6 side
Line 7 side
Setting
Line No = 0
Line No = 0
Line No = 0
Line No = 1
Line No = 0
Line No = 1
Line No = 2
Line No = 3
Line No = 4
Line No = 5
Line No = 6
Line No = 7
Remotely operating the controller (Remote Operation)
4
217